CM4371-50 / HIOKI - Japan
- DC current measurement range: 20.00 A/600.0 A
- AC current range: 20.00 A/600.0 A
- DC/AC current range: 20.00A/ 600.0A
- DC voltage range: 600.0 mV to 1000 V, 5 scales
- AC voltage range: 6,000 V to 1000 V, 4 scales
- DC/AC voltage range: 6,000 V to 1000 V, 4 scales
- Resistance measurement: 600.0 Ω to 600.0 kΩ, 4 scales
- Capacitance measurement: 1,000 μF to 1000 μF, 4 scales
- Frequency range: 9,999 Hz to 999.9 Hz
- Check continuity:  [ON] 25Ω±10 Ω, [OFF] 245Ω±10 Ω
- Check diode: Open voltage ≤ DC2.0V, short circuit current: 200 μA.
- Temperature measurement:  -40.0 to 400.0 ˚C
- Clamp fork tight diameter: φ33 mm
- DC power measurement: 0.0 kVA to 600 kVA (up to 1200kA when used with Hioki P2000)

DT4282 / HIOKI - Japan
- DC voltage measurement feature: 60 mV to 1000 V, 6 scales
- AC voltage measurement feature: 60 mV to 1000 V, 6 scales
- DC / AC voltage measurement mode: 6V to 1000 V, 4 scales
- DC current measurement feature: 600 μA to 10 A, 6 scales
- AC current measurement feature: 600 μA to 10 A, 6 scales
- Resistance measurement feature: 60 Ω to 600 MΩ, 8 scales
- Capacitance measurement feature: 1 nF to 100 mF, 9 ranges
- Check continuity: 20/50/100/500 Ω
- Diode test:  Open terminal voltage: ≤4.5 V, Test current: ≤1.2 mA

FT6380-50 / Hioki - Japan
- Ground resistance range: 0.20 Ω to 1600 Ω, 10 ranges
- AC current range: 20.00 mA to 60.0 A 5 ranges
- Current measurement: 100 A AC continuous, 200 A AC for 2 minutes or less
- Maximum rated ground voltage: 600 VAC
- Maximum measurable wire diameter: φ 32 mm (1.26 in)

FT6031-50 / Hioki - Japan
- Measuring system: 2-pole method/ 3-pole method (switchable)
- Accuracy:
±1.5% rdg ±8 dgt
±1.5% rdg ±4 dgt
±1.5% rdg ±4 dgt
- Earth voltage: Accuracy: ±2.3% rdg ±8 dgt (50 Hz/60 Hz)
±1.3% rdg ±4 dgt (DC)
- Allowable ground potential: 25.0 V rms (DC or sine wave)

IR3455 / Hioki - Japan
-  Test voltage: 250 V to 5.00 kV DC
- Voltage measurement:
0.00 MΩ to 500 GΩ (250 V)
0.00 MΩ to 1.00 TΩ (500 V)
0.00 MΩ to 2.00 TΩ (1 kV)
0.00 MΩ to 5.00 TΩ (2.5 kV)
0.00 MΩ to 10.0 TΩ (5 kV)
- Current measurement: 1 mA
- Resistance range: 10 MΩ to 10 TΩ, 7 scales
- Leakage measurement: 1.00 nA to 1.20 mA, 6 scales
- Voltage measurement: ±50 V to ±1.00 kV DC, 50 V to 750 V AC

IR4053-10 / Hioki - Japan
- Output measurement voltage: 50/125/250/500/1000 VDC. In which the 500/1000 VDC ranges can be used for solar power systems.
- Maximum resistance measurement value: 100/250/500/2000/4000 MΩ
- Lower limit resistance value: 0.05/0.125/0.25/0.5/1 MΩ
- Measure DC voltage: 4.2V to 1000V, 4 scales
- Measure AC voltage: 420V / 600V, 2 scales

IR4056-21 / Hioki - Japan
- Output measurement voltage: 50/125/250/500/1000 VDC
- Maximum resistance measurement value: 100/250/500/2000/4000 MΩ
- Lower limit resistance value: 0.05/0.125/0.25/0.5/1 MΩ
- Overload protection: AC 600V (10s) for scales < 1000 VDC and AC 1200V (10s) for scales 1000 VDC
- DC voltage measurement feature: 4.2V to 600V, 4 scales
- AC 50/60 Hz voltage measurement feature: 420V / 600V, 2 scales
- Ground wire continuity test feature: 10 Ω to 1000 Ω, 3 scales

PD3129 / Hioki - Japan
- Voltage range: 3-phase 70 to 600V AC
- Clamp head diameter: 2.4mm to 17mm
- Positive phase detection: 4 LEDs light up clockwise and the speaker beeps intermittently
- Negative phase detection: 4 LEDs light up counterclockwise and the speaker sounds continuously

PD3129-10 / Hioki - Japan
- Voltage range: 3-phase 70 to 1000V AC
- Clamp head diameter: 7mm to 40mm
- Positive phase detection: 4 LEDs light up clockwise and the speaker beeps intermittently
- Negative phase detection: 4 LEDs light up counter-clockwise and the speaker sounds continuously

8031F / Kyoritsu - Nhật Bản

- Điện áp hoạt động: 110 - 600V AC
- Cầu chì: 0.5A/600V (F)
- Thời hạn liên tục: >500V : Trong 5 Phút
- Tần số đáp ứng: 50Hz/60Hz
- Tiêu chuẩn áp dụng: IEC 61010-1 CAT III 600V Pollution Degree 2
- Điện áp chịu được: 5550V AC Trong 1 phút
- Kích thước: 106(L) × 75(W) × 40(D)mm
- Trọng lượng: 350g
- Dây: 1.5m
- Phụ kiện: Hộp đựng và hướng dẫn sử dụng

8125 / Kyoritsu - Japan
- Diameter of pliers: Ø40mm
- Current measuring range: AC 500A
- Output voltage: AC 500mV/500A
- Phase shift: ±1.0º
- Output impedance: 2Ω
- Optional accessories: Jack 7146; Extension cord 7185

8128 / Kyoritsu - Japan
- Diameter of pliers: Ø24mm
- Current measuring range: AC 5A (Max.50A)
- Output voltage: AC 50mV/5A
- Phase shift: ±2.0º (45 – 65Hz)
- Output impedance: About 20Ω
- Optional accessories: Jack 7146; Extension cord 7185

2060BT / Kyoritsu - Japan
- AC voltage: 1000 V
- Frequency: 40.0 – 999.9Hz
- Operating power: 40.00/400.0/1000kW
- Reactive power: 40.00/400.0/1000kVA
- Apparent power: 40.00/400.0/1000kVar
- Power factor (cos Ø): -1.000 – 0.000 – +1.000.
- Total harmonic THD-R/THD-F: 0.0% – 100.0%
- Phase order: ACV 80 – 1100V
- Clamp diameter: φ75 mm

2062BT / Kyoritsu - Japan
- AC voltage: 1000 V
- Crest factor: 1.7 or less
- AC current: 40/400/1000 A (3 automatic measurement ranges)
- Frequency: 40.0 – 999.9Hz
- Operating power: 40.00/400.0/1000kW
- Reactive power: 40.00/400.0/1000kVA
- Apparent power: 40.00/400.0/1000kVar
- Power factor (cos Ø):  -1.000 – 0.000 – +1.000.
- Total harmonic THD-R/THD-F: 0.0% – 100.0%
- Phase order: ACV 80 – 1100V (45 – 65Hz)
- Clamp diameter: φ55mm max

4200 / Kyoritsu - Japan
- Earth resistance test:
+ Measuring range: 20Ω/200Ω/1200Ω
+ Resolution: 0.01Ω/0.1Ω/1Ω/10Ω
- AC current test:
+ Measuring range: 100mA/1A/10A/30A
+ Display range: 0.1mA/1mA/0.01A/0.1A
- Clamp diameter: Approx. Ø32mm
- Power supply: LR6/R6 (AA)(1.5V) x 4
- Dimensions: 246(L)×120(W)×54(D)mm
- Weight (without battery): 780gc

4202 / Kyoritsu - Japan
- Earth resistance test: Measuring range: 0~20Ω/ 0~200Ω/ 0~1500Ω
- AC current test: Measuring range: 100/1000mA/10A/30A
- Clamp diameter: Approx. Ø32mm
- Power supply: LR6/R6 (AA)(1.5V) x 4
- Dimensions: 246(L)×120(W)×54(D)mm
- Weight (without battery): 780g

2432 / Kyoritsu - Japan
- AC current A: 4/40mA/100A
- Maximum loop voltage: 600V AC/DC ; 300V AC/DC
- Frequency: 20Hz~1kHz
- Diameter of pliers: Ø40mm

2433 / Kyoritsu - Japan
- Current AC A: AC A:
40/400mA/400A (50/60Hz)
(WIDE) 40/400mA/400A
- Frequency: 20Hz~1kHz (40Hz~1kHz:400A)
- Diameter of pliers: Ø40mm
- Dimensions: 185(L) × 81(W) × 32(D) mm

4105A / Kyoritsu
- Resistance: 0~20Ω/0~200Ω/0~2000Ω
- Earth voltage [50,60Hz]: 0~200V AC
- Power supply: R6P (AA) (1.5V) × 6
- Dimensions: 105(L) × 158(W) × 70(D)mm
- Weight: 550g
- Accessories: 7095A (red-20m, yellow-10m, green-5m); 8032; 7127A ; R6P (AA)×6 ; Instruction Manual

2002PA / Kyoritsu
- Clamp diameter: φ 55mm
- Measuring range: 0-2000A AC
- Frequency: 40Hz to 1kHz
- Power supply: R6 (AA) (1.5V) × 2
- Dimensions: 247×105×49mm
- Weight: ~470g
- Standard: IEC 61010-1 CAT III 600V / CAT II 1000V ; IEC 61010-2-031 IEC 61010-2-032